• Welcome to JD Fanatics Forum

Transaxle rebuild

Discussion in 'Transmissions' started by Chaser, Dec 7, 2017.

  1. Chaser

    Chaser Well-Known Member

    Just curious if anyone has any experience rebuilding the peerless 2300s. I have one almost done and was reating online that it is common for leaks where the axle tubes bolt on. Anyone have any insight on this?
     
    truck21 and Kster526 like this.
  2. Kster526

    Kster526 Well-Known Member

    1,900
    5,765
    Oley, Pa
    Ask Kyle 2 there is an o ring in there were the tube bolts onto the rear. Never had a leak there only at the end of the axle tube itself
     
    KAJD23, truck21 and Chaser like this.

  3. Chaser

    Chaser Well-Known Member

    I replaced both of those o-rings and the seals. Just curious if I should expect it to leak anyhow or not.
     
    KAJD23, Kster526 and truck21 like this.
  4. Kster526

    Kster526 Well-Known Member

    1,900
    5,765
    Oley, Pa
    No you should be ok unless the axle is worn bad were the seal hits the axle. Takes longer to get it apart then the put the new seals in
     
    KAJD23, Chaser and truck21 like this.