[PA212]

I scored another 43 blade for my 212 including most of the angling kit! Unfortunately it wasn't with the tractor when it was given to me so I'm missing a few parts.

From the video I found on line it appears that I'm missing the rod support that goes on the side of the tractor, the push/pull rod and the piece that holds the rod at the top of the blade mount. Does anyone have an extra tucked away?

Dave

 

[Kster526]

ONLY HAVE ONE AND USE IT SORRY, IF YOU NEED I CAN TAKE A PIC SO YOU CAN FAB ONE UP.I THINK BACKWOODS HAD MADE ONE OF HIS OWN AWHILE BACK

 

[PA212]

Photos and a couple of measurements would be greatly appreciated. I'll have to go look for Backwoods post also.

 

[Kster526]

DO MY BEST TO REMEMBER THIS WEEKEND FOR YOU ………….

 

[backwoods]

i did make a template for the whole angle set up but that is as far as i got as i turned the blade into a hydro for on my 300

 

[Kster526]

Actually found a manual and pics I had
Rod is 35 1/2 inches from front to back side of D handle and is 3/8 thick

 

[Kster526]

A few more to help you
Not sure if I covered the piece you need yet. Let me know

 

[PA212]

Thank you! The photos definitely help. Only thing I don't think that you covered is piece 17 which holds the rod on the side of the tractor. When you have a chance could you grab a few of that piece please? Photos with the tape measure in them are great!

Happy Thanksgiving BTW.

Dave

 

[Kster526]

That is just mounted the the side of the tractor with a 5/16 bolt thru a plate
If you look at the pics of the 212 in the photos there is one there . I can take one of mine e hopefully tomorrow for you

 

[Kster526]

The pics you requested

 

[PA212]

Thank you Kyle! Now I need to start looking to find materials to put something together....