JD Fanatic Forums banner
1 - 1 of 1 Posts

· Registered
20 Posts
Discussion Starter · #1 ·
So i am rebuilding my K181 and i noticed the can weights have been rubbing on the intake tappet. Has anyone else run into this? I am getting ready to start reassembling the engine after getting it back from the machine shop. The cam weights are loose, not sure f they can be tightened up or not. Also the bottom of the cylinder is chipped out, from what i have read it will not hurt anything. I will try and attach some pictures. Thanks for any help.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.