JD Fanatic Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter #1
Hi All,

Here is an unusual problem that I would like to fix: I have an old 724 snow blower which I bought new many years ago and am fond of. I recently tried to run over it with my truck. I bent the shroud around the blades so that it does not sit flush to the ground on one side. It has about a 1-2" lift on that side. Using the handle I can actually push down that side and pick up the other handle to force the snow blower "flat", but that is "real" work.
Any thoughts on a method of straightening the shroud? I thought about using a large strap wrench with an even large pipe on the end.
I will use it bent but would like to get it fixed!

Thanks,

george
 
1 - 1 of 1 Posts
Top