JD Fanatic Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter #1
I have SBH172a engine I am rebuilding. It was in pieces when I got it. Getting ready to put it back together. My governor spool does not have a hole in the top. Is it suppose to have a hole in it or is that one of the differences between it and the HH100?

Also since it was tore down before I got it what side does the hole on the rod sit that goes on the crank shaft, right or left?

Thanks again for all the help. This site is a wealth of knowledge.
 

·
Registered
Joined
·
22 Posts
Does that have the spring on it that can go both ways? I fiddled with one before that I had to look at the pic. in the service manual that I borrowed from the neighbor. Now I'm danged to remember. If it has the swivel spring, I believe the hole goes the the right side.
 
1 - 2 of 2 Posts
Top