• Welcome to JD Fanatics Forum

Adding the lines in

Discussion in 'Hydraulics' started by backwoods, Dec 23, 2016.

  1. backwoods

    backwoods Well-Known Member

    So I picked up the lines from.another member so I can run a 4 way blade does anyone have pictures or can help me as to where the lines should connect to the valve?? This is on my 300 that I currently have torn down to.the frame.
     
    johndeereelfman, Kster526 and truck21 like this.
  2. truck21

    truck21 Moderator Staff Member

    784
    2,381
    Manheim Pa
    Greg, you may have to change the valve and use the one I sent with you.
     
    johndeereelfman and Kster526 like this.

  3. backwoods

    backwoods Well-Known Member

    There wasn't a valve in the bag only a cylinder I didn't notice till I got home
     
    johndeereelfman, Kster526 and truck21 like this.
  4. truck21

    truck21 Moderator Staff Member

    784
    2,381
    Manheim Pa
    OK I'll have a look in the shed and see if the valve is in there. Do you have both handles?
     
    johndeereelfman and Kster526 like this.
  5. backwoods

    backwoods Well-Known Member

    Yes I have the handles but after looking at the pictures you sent me an looking at my valve the two top lines are t's those are what I'm missing is all to connect the lines
     
    Kster526, johndeereelfman and truck21 like this.
  6. truck21

    truck21 Moderator Staff Member

    784
    2,381
    Manheim Pa
    Yeah I kinda thought so. Sorry about that my friend I truly planned on you getting the valve. Hope you can pick up the t's locally if not let me know and I will pull these off and send them.
     
  7. backwoods

    backwoods Well-Known Member

    Im going to pull a 90 out of my valve an take it to work an see if i can get a t
     
    Kster526, johndeereelfman and truck21 like this.